BA15S P21W 1156 LED CANBUS CAN-BUS ERROR LOAD RESISTOR FIX OBC DECODER

£7.99

Product Features:

£7.99

Specifications:

You are bidding on one Led decoder OBC error fix for your motor vehicle which will cure the fix hyper flash or on board computer error IE, blown bulb out of installing led bulbs in your motor vehicle.  Our led decoders are the same led decoders as used by the professionals and as such they of a high quality thoroughly tested throughout.

Our led decoder will stop the OBC warning or error that is thrown by your cars canbus warning system when you have installed a led bulb.

As this led decoder can get extremely hot under normal use please see our picture below and mount this middle part that reads ”led decoder” to your cars metal surface and keep it away from your cars wiring loom.

 photo DIAGRAMBA15S_zps4033872a.gif

 photo P1010131_zps07a67a86.jpg photo P1010128_zpse5f80e1b.jpg photo P1010129_zpsa3e9d6f9.jpg

Main Features:

BA15S wiring harness with pre-wired sockets and built-in LED decoder and resistor Also can be used to cancel the OBC or Bulb-Out warning after install LED bulbs Can be used to fix the hyper flash of the turn signal after installing LED bulbs Fully plug and play, simply plug the LED bulb to the socket of the canceller, then insert the plug of the canceller to the factory socket Solve problem of warning or blinking.

TOTAL LENGTH OF THIS DECODER IS 30CM OR 300MM FITTING IS BA15S 1156 P21W PRIMARILY USED TO INSTALL LED BULBS TO VEHICLES TO CURE THE HYPER FLASH OR OBC WARNING ON MOTOR VEHICLES REQUIRING A RESISTOR OR THIS FITTING.

SHIPPING COSTS ARE UK ONLY

Related Products: